Built 8.2 deck 5.0 and on3 turbo kit.
Built 8.2 deck 5.0 and on3 turbo kit.
Seller Information
Looking to sell mine small block 306 with the turbo kit. I wanna sell this engine and turbo kit complete as you see it intake to the oil pan. It is bored .030 over and decked .005. It is a stock crank engine with scat rods, and forged aluminum flat top D.S.S Racing pistons. The entire rotating assemble was balanced to accommodate for all the new parts. The cylinder heads are a GT40 3 bar iron head milled .005 and machined with lock wire into them for power adder. The heads are gasket matched ported and polished, and are machined for double valve springs. They have a trick flow double spring in them and a 1.6 Proform pedestal mount roller rocker. They are fastened down with ARP head studs. The setup is running a lunati cam ground for boost. The intake is a GT40 upper and lower also gasket matched ported and polished. The setup will also include a full on3 70mm turbo kit. I am also including the PMAS blow through MAF, 60lbs siemens deka injectors, and fuel rails with a brand new aeromotive fuel pressure regulator and gauge. I am also including the moates quarterhose chip with the tune on it. The setup made roughly 500hp to the rear wheels on 93 octane pump gas. The setup is still in my car and running perfect. I am not pulling it until its sold. Roughly 5K miles on the whole setup. The only reason I am selling this setup is because I am looking to go in a different direction with the car. I am asking $4500 OBO for the complete setup. any questions call or text. 440-8five8-5673
Payment: Cash
Shipping: Buyer Pays Shipping